SSOUNDS · SS-P15XA
SSOUNDS P15-XA
액티브 3웨이 증폭 방식의 P15-X, 각 섹션을 완전히 DSP로 제어하는 동일한 3웨이 롱스로우 패키지입니다.
P15-XA는 P15-X의 액티브 3웨이 증폭 버전입니다. 동일한 두 개의 15인치 LF 드라이버, 네 개의 6.5인치 미드레인지, 그리고 70° × 40° 웨이브가이드에 장착된 한 쌍의 3인치 컴프레션 드라이버를 갖추고 있지만, 각 섹션은 시스템 DSP 앰프에서 독립적으로 공급됩니다. 이를 통해 시스템 엔지니어는 크로스오버 슬로프, 정렬 지연, 밴드별 리미팅을 직접 제어할 수 있으며, 이는 어려운 공간에서 롱스로우 작업을 할 때 중요합니다. 앰프 채널이 부족한 경우에는 패시브 P15-X를 지정하십시오.
P stands for Point Source. A single acoustic origin rather than a coupled array: coverage is set by the cabinet's own horn, and is the same whether one is deployed or several.
Key features
- Actively tri-amplified, independent LF, MF and HF sections
- 2 × 15″ LF, 4 × 6.5″ MF and 2 × 3″ HF compression drivers
- 70° × 40° constant-directivity waveguide for long throw
- 145 dB peak SPL with 45 Hz reach
- Per-band crossover, delay and limiting from the system DSP
- NL8 connectivity, one cable per cabinet
Specifications
Engineering data. The conditions each figure is specified under are stated below the table.
General
- Type
- 3-way point source · actively tri-amplified
- Certifications
- CE · TÜV · EAC · WEEE
Components
- Low frequency
- 2 × 15″ cone drivers · 8 Ω
- Mid frequency
- 4 × 6.5″ forward-facing cone drivers with phase plug, 50% waveguide-loaded · 8 Ω
- High frequency
- 2 × 1.4″ exit compression drivers, 3″ coil · 16 Ω
Acoustic
Electrical
Connections
- Connectors
- 2 × NL8 speakON (in / link)
- Pin map
- 1+/1− LF · 2+/2− MF · 3+/3− HF · 4+/4− not linked
Rigging
- Mounting
- M10 fly points · yoke bracket · flown or ground-stacked
Physical
Measurement conditions
- Maximum SPL is the peak level at 1 m, driven with pink noise at crest factor 4 to the clipping point of the recommended amplifier, with the SSOUNDS system preset applied. Full-range enclosures are specified under free-field conditions; figures marked half-space are specified over a reflecting plane, the condition subwoofers are deployed in, which adds approximately 6 dB.
- Frequency response is specified on axis at 1 m in a free field. The tolerance the figure is referenced to is stated alongside it; where no tolerance is given, the figure is the −6 dB bandwidth.
- Sensitivity is specified at 1 W into the nominal impedance at 1 m on axis, averaged across the pass band of the enclosure.
- Coverage angles are nominal −6 dB values averaged across the pass band. Per-octave directivity data is available from SSOUNDS system design support for prediction and modelling.
- Recommended amplifier power is the amplifier output SSOUNDS specifies for this enclosure, driven with the SSOUNDS system preset. It guides amplifier selection and is not an AES power-handling rating for the transducers.
- Nominal impedance is the manufacturer's rating for amplifier load calculation; minimum impedance across the operating band may be lower.
- Net weight excludes packaging, flight case, accessories and optional rigging hardware.
- Dimensions are stated in millimetres and exclude protruding rigging hardware, handles and connector panels unless noted.
- All figures are typical values for production units specified under the conditions above. Individual units may vary within published tolerances.
Directivity
Directivity computed by the SSOUNDS system prediction engine from this product's driver complement, the same dataset the printed data sheet uses. 1/24-octave band-power resolution; values are dB relative to on-axis.
System operation
Recommended: SSOUNDS D24X, one amplifier per P15-XA in tri-amplified mode with the P15-XA preset loaded.
Downloads
Product documentation, free to open. No registration, no form. The data sheet is a PDF rendered from the page below it; the manual is a print page, so use your browser to print it or save it as PDF.
- Technical data sheetFull specification set with the measurement conditions for each figure, modelled response curves, safety notices and warranty terms.PDF · SS-DS-P15XA-EN-A4 · Rev. 2608 · Issued 14 Aug 2026
- Technical data sheet, in your browserThe same document as a page, if you would rather read it here or print it yourself.HTML print view · SS-DS-P15XA-EN-A4 · Rev. 2608 · Issued 14 Aug 2026
- Architectural and engineering specificationThe “shall be” paragraph for tender documents and bills of quantities, written from this product’s own specification rows. Section of the data sheet.HTML section · SS-DS-P15XA-EN-A4
- User manualUnpacking, connection, installation, operating limits, maintenance schedule and troubleshooting for this model.HTML print view · SS-UM-P15XA-EN-A4 · Rev. 2608 · Issued 14 Aug 2026
- Directivity table, horizontal axisPolar data in dB relative to on axis, in the layout a measurement rig exports, for prediction and modelling. Computed by the SSOUNDS prediction engine, not measured in an anechoic chamber.CSV download
- Directivity table, vertical axisPolar data in dB relative to on axis, in the layout a measurement rig exports, for prediction and modelling. Computed by the SSOUNDS prediction engine, not measured in an anechoic chamber.CSV download
Loudspeaker data files for prediction software (GLL and CLF for EASE), 2D and 3D drawings and certification documents are issued on request. Email support@s-soundspro.com and we will send the current release for this model.
Amplification
System amplifier named in this product's specifications.
